Section 2: Circuit Requirements; 220V Single-Phase - Grizzly G0592 Owner's Manual

SECTION 2: CIRCUIT REQUIREMENTS

220V Single-Phase

Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
Amperage Draw
The Model G0592 motor draws the following
amps under maximum load:
Motor Draw at 220V .............................. 15 Amps
Circuit Requirements
We recommend using a dedicated circuit for this
machine. You MUST connect your machine to a
grounded circuit that is rated for the amperage
given below. Never replace a circuit breaker on
an existing circuit with one of higher amper-
age without consulting a qualified electrician to
ensure compliance with wiring codes. If you are
unsure about the wiring codes in your area or
you plan to connect your machine to a shared
circuit, consult a qualified electrician.
220V Circuit ........................................... 20 Amps
Plug/Receptacle Type
Recommended Plug/Receptacle ....NEMA L6-20
Figure 3. NEMA L 6-20 plug and receptacle.
G0592 Metal Cutting Bandsaw
Grounding
In the event of an electrical short, grounding
reduces the risk of electric shock. The grounding
wire in the power cord must be properly connect-
ed to the grounding prong on the plug; likewise,
the outlet must be properly installed and ground-
ed. All electrical connections must be made in
accordance with local codes and ordinances.
Electrocution or fire could
result if this machine is
not grounded correctly
or if your electrical con-
figuration does not com-
ply with local and state
codes. Ensure compliance
by checking with a quali-
fied electrician!
Extension Cords
We do not recommend the use of extension
cords. Instead, arrange the placement of your
equipment and the installed wiring to eliminate
the need for extension cords.
If you find it absolutely necessary to use an
extension cord at 220V with your machine:
• Use at least a 12 gauge cord that does not
exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• A qualified electrician MUST size cords over
50 feet long to prevent motor damage.
-11-