Grizzly G0592 Owner's Manual page 33

Fill Cap
Figure 39. Gear box lubrication.
5.
Replace the drain plug, then lower the bow to
its lowest position.
6.
Open the fill cap and fill the gearbox with oil
until you see the oil level reach the halfway
point in the sight glass (see Figure 39).
7. Tighten the fill plug, connect the machine
to power and run the saw for a minute or
two—then reinspect the oil level. Add more
oil if needed to maintain level at the halfway
mark in the sight glass.
G0592 Metal Cutting Bandsaw
Sight Glass
8.
Lubricate the leadscrew as needed with
general purpose grease. Apply a thin layer
all along the leadscrew surface (see Figure
40).
Leadscrew
Figure 40. Vise leadscrew lubrication area.
-31-