Shipping Bracket; Workstop - Grizzly G0592 Owner's Manual

Shipping Bracket

A bracket has been installed to keep the saw in
alignment during shipping. Before using your saw
you will need to remove it. Store it for safe keep-
ing, in the event you move your saw to a different
location.
Figure 8. Shipping bracket.
To remove the shipping bracket:
1. Remove the upper hex bolt with a 12mm
wrench.
2. Remove the two lower cap screws with a
5mm hex wrench.
G0592 Metal Cutting Bandsaw

Workstop

The workstop on the Model G0592 has three main
parts including the workstop rod, arm and work-
stop. The workstop is easy to adjust and can be
set up on either side of the vise.
To install the workstop:
1.
Slide the workstop rod in the hole in the base
of the vise and tighten the set screw.
2. Slide the arm onto the workstop rod and
tighten the set screw.
Set screw
Set screw
Figure 9. Workstop assembly.
3.
Insert the workstop into the arm and secure
with the knob.
Workstop
Figure 10. Workstop.
Arm
Workstop Rod
Knob
-17-