SECTION 8: SERVICE ADJUSTMENTS
Blade Parallelism
The Model G1022 Series Table Saws will perform
best when the miter slot is parallel to the blade.
To check and adjust blade parallelism:
1.
Disconnect the machine from the power
source!!
2.
Tilt the blade to 90˚. Using an adjustable
square, measure the distance (A) between
the miter slot and the front of the blade as
shown in Figure 59.
G1022 Series Table Saws
Use caution and remain
alert
when
working
around the saw blade.
Failure to follow this
warning could result in
serious personal injury
or death.
Figure 59. 90° blade parallelism measurement.
3.
Rotate the blade 180° and measure the dis-
tance (B) between the miter slot and the
back of the blade as shown in Figure 60.
Figure 60. 90° blade parallelism measurement.
!
!
-49-