Grounding; Extension Cord - Grizzly & G1022PROZX Instruction Manual

Grounding

Electrocution or a fire
could result if the table
saw is not grounded cor-
rectly. Make sure all
electrical circuits are
grounded. DO NOT use
the machine if it is not
grounded.
NOTICE
The wire on the power cord with green or
green and yellow striped insulation is the
grounding conductor.
G1022 Series Table Saws
In the event of an electrical short, grounding pro-
vides electric current a path of least resistance to
reduce the risk of electrical shock to the operator.
Ground the power cord and this machine in accor-
dance with all local codes and ordinances.
Operating the machine when it is not properly
grounded can result in electric shock or electro-
cution.

Extension Cord

Should it be necessary to use an extension make
sure the cord is rated Hard Service (grade S) or
better. Refer to the chart in Section 1: Safety
Instructions to determine the minimum gauge for
the extension cord. The extension cord must also
contain a ground wire and plug pin. Always repair
or replace extension cords when they become
worn or damaged.
No single list of electrical guidelines can
be comprehensive for all shop environ-
ments. Operating this machinery may
require additional electrical upgrades spe-
cific to your machine and shop environ-
ment. It is your responsibility to make sure
your electrical systems comply with all
local electrical codes and ordinances.
-11-