Lubrication; Table; V-Belt - Grizzly & G1022PROZX Instruction Manual

Lubrication

The sealed ball bearings in the motor and
throughout the Model G1022 require no mainte-
nance during their lifetime. When they do wear
out, replacements can be obtained through the
Grizzly Parts Department.
Lubricate the areas indicated below every 12
months:
BLADE ANGLING TRUNNION—The front and
back trunnions each have a semi-circle groove
that needs to be lubricated with an automotive
wheel bearing grease.
BLADE HEIGHT TRUNNION—The blade height
trunnion pivots on a steel rod. This should be
lubricated with 6 or 7 drops of light machine oil.
WORM GEARS ( Figure 58)— These should be
lubricated with an automotive wheel bearing
grease.
Lubrication Points
Figure 58. Worn gear lubrication points.
G1022 Series Table Saws

Table

The table is made from cast iron. If preventative
measures are not taken, the table surface will rust.
Regularly wipe sawdust from the table to prevent
rust causing moisture from becoming trapped
against the table. Regular applications of products
®
like SLIPIT will prevent rust as the saw is used on
a daily basis. For long term storage, use products
such as Boeshield T-9
are available in the Grizzly catalog.

V-Belt

Inspect the V-belt regularly for tension and wear.
Check the pulleys to ensure they are correctly
aligned. Refer to Section 5: Set Up beginning on
Page 23 for instructions on adjusting the V-belt.
®
. Both of these products
-47-