Switch; Motor - Grizzly & G1022PROZX Instruction Manual

15. Using the supplied wing nut and mounting
bolt, secure the pulley cover over the pulley
and V-belt as shown in Figure 22.
Figure 22. Attached pulley cover.
-24-

Switch

Models SM & Z:
The ON/OFF switch, with attached power cord
and plug, is already mounted to the saw enclo-
sure. Connect the quick disconnect on the cord
between the switch and motor.
Models ZF, ZFX, PROZ, & PROZX:
The ON/OFF switch on the Models ZF, ZFX,
PROZ, & PROZX mounts directly below the front
fence rail.
To install the switch:
1. Disconnect the machine from the power
source!!
2. Position the L-shaped mounting bracket
below the left-hand side of the front fence
rail. The shorter side of the L has two holes
which will align with two holes in the fence
rail.
3.
Secure the bracket to the rail using M8-1.25
x 9 hex bolts and M8 flat washers (Model
PROZ: M8-1.25 x 15 countersunk phillips
head screws, M8-1.25 hex nuts, and M8 flat
washers).
4. Secure the switch to the bracket using M4-
0.7 x 14 phillips head screws and M4 flat
washers. The screws thread through the
back of the bracket and into threaded inserts
in the back side of the switch box.
5.
Connect the plug on the cord between the
switch and motor.
G1022 Series Table Saws