Blade Guard - Grizzly & G1022PROZX Instruction Manual

Blade Guard

To install the blade guard:
1. Disconnect the machine from the power
source!!
2. Screw the threaded end of the support shaft
into the hole in the back of the rear trunnion.
The check nut on the shaft will be used to
tighten the shaft in place as shown in Figure
36. Leave it loose for now.
Figure 36. Installing blade guard.
3. Loosen the blade-guard mounting bolt locat-
ed just inside the table cut-out and the blade
guard mounting bolt on the end of the sup-
port shaft.
4. Slip the slots at the bottom of the guard over
the two mounting bolts as shown in Figure
37. The washers should be between the bolt
head and the slots.
G1022 Series Table Saws
Use caution and remain
alert when working
around the saw blade.
Failure to follow this
warning could result in
serious personal injury
or death.
Blade Guard Mounting Bolts
Blade Guard
Support Shaft
Figure 37. Blade guard components.
5. Rotate the support shaft to align the mount-
ing bolts to the mounting slots on the guard.
6. Tighten the mounting bolts to secure the
blade guard.
7. Using a machinist's or a combination square,
align the face of the splitter perpendicular to
the surface of the saw table as shown in
Figure 38.
Figure 38. Adjusting blade guard.
8. Rotate the support shaft slightly. This will
normally correct any minor misalignment.
!
!
Support Shaft
-31-