Copying Effect Settings - Roland V-Drums TD-30 Owner's Manual

Meters shown in the MASTER
COMPRESSOR screen
In the MASTER COMPRESSOR screen, the "input meter, "
the "gain reduction meter, " and the "output meter" are
displayed.
Input meter
The "input meter"
shows the level (dB) be-
ing input to the master
comp/master EQ.
Output meter
The "output meter" shows the output level
following the master comp and EQ.
Adjust the master comp's "Gain" so that the output meter
does not exceed 0 dB (i.e., so that it does not clip).
* The output meter shows only the level of the output
signal from the MASTER OUT jacks.
Turning the Master Comp/ Master EQ
On/Off
1.
Press the [MASTER COMP] button .
The [MASTER COMP] button will light.
2.
Press the [F1] button to turn the master comp/
master EQ on/off .
This is the same setting as turning master comp/master
on/off in the EFFECTS SWITCH screen (p. 67).
Gain reduction meter
The "gain reduction
meter" shows the change
in level (dB) produced by
the master comp.

Copying Effect Settings

Here's how a drum kit's ambience section settings or
multi-effect settings can be copied to another drum kit
in a single operation. You can also copy from a drum kit
that's in preset memory or on a USB flash drive.
If you're copying from user memory, you can exchange
the copy-source and copy-destination settings.
NOTE
When you execute the copy, the contents of the
copy-destination will be overwritten. If you want to
keep those settings, back them up to a USB flash drive
before you continue (p. 108).
1.
Hold down the [SHIFT] button and press the
[USB MEM] button .
The [USB MEM] button will light, and the COPY A screen
will appear.
2.
Press the [F5] (A B C) button to access the
COPY B screen .
3.
Use the [F3] (AMB) or [F4] (MFX) button to select
the effect setting that you want to copy .
(Example: When [F4] (MFX) is selected)
Copy-source
Copy-destination
4.
Use the [F1]–[F3] buttons to select the copy-
source .
Button
[F1] (USER) button
[F2] (PRESET) button
[F3] (USB) button
Effects
Explanation
Copy from user memory.
Exchanging the copy-source and
copy-destination is possible only if
the copy-source is user memory.
Copy from preset memory.
You can choose from TD-30 or TD-
20X preset data. Select this if you
want to return to the factory-set
settings.
Copy from backup data saved on a
USB flash drive.
79