Table of Contents
Advertisement
REAR BRAKE SHOE INSPECTION / BRAKE FLUID LEVEL
INSPECTION (TT-R125LE) / SPROCKETS INSPECTION
REAR BRAKE SHOE INSPECTION
1. Inspect:
• Brake shoe lining wear limit
Brake shoe lining wear limit checking
steps:
• Fully push down the brake pedal and hold it
in position.
• Then check the brake shoe wear indicator
1 is within the wear limit a.
Outside the limit → Replace the brake shoe.
Refer to "REAR WHEEL AND REAR BRAKE"
section in the CHAPTER 5.
BRAKE FLUID LEVEL INSPECTION
(TT-R125LE)
1. Place the brake master cylinder so that its
top is in a horizontal position.
2. Inspect:
• Brake fluid level
Fluid at lower level → Fill up.
a Lower level
Recommended brake fluid:
DOT #4
WARNING
• Use only designated quality brake fluid to
avoid poor brake performance.
• Refill with same type and brand of brake
fluid; mixing fluids could result in poor
brake performance.
• Be sure that water or other contaminants
do not enter brake master cylinder when
refilling.
• Clean up spilled fluid immediately to avoid
erosion of painted surfaces or plastic
parts.
SPROCKETS INSPECTION
1. Inspect:
• Sprocket teeth a
Excessive wear → Replace.
TIP
Replace the drive, driven sprockets and drive
chain as a set.
3-21
INSP
ADJ
Hide quick links:
Advertisement
Table of Contents
