Table of Contents
Advertisement
EC240000
CABLE ROUTING DIAGRAM
1 Ground lead
2 Primary coil lead
3 Clamp
4 Wire harness
5 Starter relay lead
6 Rectifier/regulator lead
7 CDI magneto lead
8 Air vent hose
9 Neutral switch lead
0 Rear shock absorber assembly
sub-tank hose (TT-R125LE
only)
A Starting circuit cut-off relay lead
B CDI unit lead
C Corrugated tube
CABLE ROUTING DIAGRAM
D Brake hose holder
(Brake cable
holder for the TT-R125E)
E Brake hose (Brake cable for
the TT-R125E)
F Cable guide
G Main switch lead
H Engine stop switch lead
I Clutch switch lead
J Start switch lead
K CDI unit band
L CDI unit
M Connector cover
N Rubber cover
O Engine oil breather hose
2-26
SPEC
P Frame
Q Rectifier/regulator
A Fasten the primary coil lead
and ground lead.
B Fasten the wire harness at its
tape.
C Fasten the wire harness and
CDI magneto lead in front of
the rear shock absorber
assembly bracket at the
protecting tube for the CDI
magneto lead.
D After fastening the starter relay
lead, pass it on the left of the
chassis.
Hide quick links:
Advertisement
Table of Contents
