Yamaha TT-R125EY Service Manual page 152

CDI MAGNETO AND STARTER CLUTCH
A
B
E
4
1
3. Check:
• Starter clutch operation
1
• Install the starter clutch drive gear 1 onto
the starter clutch 2 and hold the starter
clutch.
2
• When turning the starter clutch drive gear
counterclockwise B, the starter clutch and
the starter clutch drive gear should engage.
If the starter clutch drive gear and starter
clutch do not engage, the starter clutch is
faulty and must be replaced.
• When turning the starter clutch drive gear
clockwise A, it should turn freely. If the
starter clutch drive gear does not turn freely,
the starter clutch is faulty and must be
replaced.
EC4L5000
ASSEMBLY AND INSTALLATION
CDI magneto
1. Install:
• Stator 1
• Bolt (stator)
• Lead guide
• Screw (lead guide) 2
• Pickup coil 3
• Bolt (pickup coil)
2. Install:
• Stater idle gear 1
• Plate 2
• Bolt 3
• Washer 4
TIP
Apply the engine oil on the starter idle gear inner
2
3
circumference.
4-59
ENG
10 Nm (1.0 m · kg, 7.2 ft · lb
7 Nm (0.7 m · kg, 5.1 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb
7 Nm (0.7 m · kg, 5.1 ft · lb)