Set Up Instructions - Stamina CPS 9190 Indoor Cycle Owner's Manual

SET UP INSTRUCTIONS

Place the CPS 9190 Indoor Cycle in the area where it will be used. It is recommended that the CPS 9190
Indoor Cycle be placed on an equipment mat. The CPS 9190 Indoor Cycle is approximately 50 inches
long (max.) x 18 3/8 inches wide x 42 5/8 inches tall (max.). An area 4 feet wide x 6 feet long is required
for safe operation of the CPS 9190 Indoor Cycle. Make sure that adequate space is available for access
to and passage around the CPS 9190 Indoor Cycle.
LEVELING: Adjust the STANDS(51) under the FRONT and REAR STABILIZER(3, 4) so that the CPS
9190 Indoor Cycle sits on the floor without rocking. Refer to the instructions below the
illustration.
MOVING: The CPS 9190 Indoor Cycle has a pair of WHEELS(49) on the FRONT STABILIZER(3).
Lift up the REAR STABILIZER(4) to move the CPS 9190 Indoor Cycle.
Equipment Mat
FUNCTION INSPECTION:
Visually inspect the CPS 9190 Indoor Cycle to verify that assembly is as shown in the above illustration.
Check the function of the CPS 9190 Indoor Cycle by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(34) to verify that the
adjustable tension is working properly.
CAUTION: Locate and read the WARNING LABEL(70) on the CPS 9190 Indoor Cycle. Make sure that
all users read the WARNING LABEL(70).
Loosen the NUTS(M8x1.25)(67) until they
touch the STANDS(51). Adjust the STANDS(51)
for leveling. Tighten the NUTS(M8x1.25)(67)
securely against the STABILIZERS(3, 4) to lock
the STANDS(51) in position.
9