Set Up Instructions - Stamina 346 Owner's Manual

SET UP INSTRUCTIONS

Place the Stamina® Recumbent Exercise Bike 346 in the area where it will be used. It is recommended
that the Stamina® Recumbent Exercise Bike 346 be placed on an equipment mat. The Stamina®
Recumbent Exercise Bike 346 is approximately 57.7 inches long (max.) x 21.1 inches wide x 42 inches
tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 7 feet long is required for safe
operation of the Stamina® Recumbent Exercise Bike 346. Make sure that adequate space is available
for access to and passage around the Stamina® Recumbent Exercise Bike 346.
LEVELING: Adjust the LEVELING CAPS(39) on the REAR STABILIZER(6) so that the Stamina®
Recumbent Exercise Bike 346 sits on the floor without rocking.
MOVING: The Stamina® Recumbent Exercise Bike 346 has a pair of Wheels in the WHEEL
CAPS(38) on the FRONT STABILIZER(3). Lift up the REAR STABILIZER(6) to move the
Stamina® Recumbent Exercise Bike 346.
FUNCTION INSPECTION:
Visually inspect the Stamina® Recumbent Exercise Bike 346 to verify that assembly is as shown in the
above illustration. Check the function of the Stamina® Recumbent Exercise Bike 346 by turning the
crank slowly through one complete revolution to verify that the drive train functions properly. Adjust the
TENSION KNOB(29) and verify that it functions properly and the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(80) on the Stamina® Recumbent Exercise Bike
346. Make sure that all users read the CAUTION LABEL(80) before using the product.
Equipment Mat
(not included)
12