Set Up Instructions - Stamina 15-7250B Owner's Manual

SET UP INSTRUCTIONS

Place the Magnetic Fusion 7250 Bike in the area where it will be used. It is recommended that the Magnetic
Fusion 7250 Bike be placed on an equipment mat. The Magnetic Fusion 7250 Bike is approximately 55 3/4
inches long x 24 3/8 inches wide x 50 3/8 inches tall (max.). (These dimensions may vary up to one inch.)
An area 4 feet wide x 7 feet long is required for safe operation of the Magnetic Fusion 7250 Bike. Make
sure that adequate space is available for access to and passage around the Magnetic Fusion 7250 Bike.
LEVELING: To level the Magnetic Fusion 7250 Bike, first screw the STAND(68) located in the middle of
the FRONT FRAME(1) all the way up into the FRONT FRAME(1) so that it is not touching the
floor. Adjust the four FOOT STANDS(64) on each of the four corners, two under FRONT
STABILIZER(2) and two under the REAR STABILIZER(6). When the FOOT STANDS(64)
are adjusted and the Magnetic Fusion 7250 Bike is stable, rotate the STAND(68) to make it
contact with the floor.
While you are adjusting the FOOT STANDS(64) the STAND(68) must not be in contact with
the floor. Only after the Magnetic Fusion 7250 Bike has been stabilized with the FOOT
STANDS(64) will you position the STAND(68) so it is in contact with the floor to provide extra
stability for the frame.
MOVING: The Magnetic Fusion 7250 Bike has a pair of WHEELS(118) built into the LEFT and RIGHT
FOOT CAPS(119, 120) at the front. Lift up the REAR STABILIZER(6) to move the Magnetic
Fusion 7250 Bike.
FUNCTION INSPECTION:
Visually inspect the Magnetic Fusion 7250 Bike to verify that assembly is as shown in the above illustration.
Check the function of the Magnetic Fusion 7250 Bike by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Use the UP and DOWN buttons on the COMPUTER
(27) to select a program and verify that the Magnetic System provides different tensions. Refer to the
COMPUTER INSTRUCTIONS on pages 15 to 19.
CAUTION: Locate and read the WARNING LABEL(109) on the Magnetic Fusion 7250 Bike. Make sure
that all users read the WARNING LABEL(109).
EQUIPMENT MAT
(not included)
13