Set Up Instructions - Stamina Elite Total Body 15-9122A Owner's Manual

SET UP INSTRUCTIONS

Place the Stamina® Elite Total Body Recumbent Bike in the area where it will be used. It is recommended
that the Stamina® Elite Total Body Recumbent Bike be placed on an equipment mat. The Stamina®
Elite Total Body Recumbent Bike is approximately 49.6 inches long x 23.6 inches wide x 48.6 inches tall.
(These dimensions may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation
of the Stamina® Elite Total Body Recumbent Bike. Make sure that adequate space is available for access
to and passage around the Stamina® Elite Total Body Recumbent Bike.
LEVELING: Place the Stamina® Elite Total Body Recumbent Bike on a flat surface and equipment
mat to set it on the floor without rocking. Adjust the STAND(65) under the REAR FRAME(2)
to get more support for the base of the Stamina® Elite Total Body Recumbent Bike.
MOVING: The Stamina® Elite Total Body Recumbent Bike has a pair of WHEELS(76) on the
FRONT STABILIZER(8). Lift up the REAR STABILIZER(9) to move the Stamina® Elite
Total Body Recumbent Bike.
Equipment Mat
FUNCTION INSPECTION:
Visually inspect the Stamina® Elite Total Body Recumbent Bike to verify that assembly is as shown in
the above illustration. Check the function of the Stamina® Elite Total Body Recumbent Bike by turning
the pedal and then handlebar slowly through one complete revolution to verify that the drive train functions
properly. Adjust the TENSION KNOB(21) and verify that it functions properly and the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(122) on the Stamina® Elite Total Body Recumbent
Bike. Make sure that all users read the CAUTION LABEL(122) before using the product.
Loosen the NUT(M8x1.25) until they touch the
LEVELING STAND(65). Adjust the LEVELING
STAND(65) for leveling. Tighten the NUT
(M8x1.25) securely against the REAR FRAME(2)
to lock the stand in position.
12
Nut