Set Up Instructions - Stamina 15-0344A Owner's Manual

SET UP INSTRUCTIONS

Place the Stamina® Exercise Bike in the area where it will be used. It is recommended that the
Stamina® Exercise Bike be placed on an equipment mat. The maximum operation dimensions of the
Stamina® Exercise Bike are approximately 47.3 inches long x 50.1 inches wide x 55.5 inches tall. (These
dimensions may vary up to one inch.) An area 6 feet wide x 6 feet long is required for safe operation of
the Stamina® Exercise Bike. Make sure that adequate space is available for access to and passage
around the Stamina® Exercise Bike.
LEVELING: Adjust the LEVELING CAPS(80) on the REAR STABILIZER(106) at the back so that the
Stamina® Exercise Bike sits on the floor without rocking.
MOVING: The Stamina® Exercise Bike has a pair of MOVING WHEELS(101) on the REAR
STABILIZER(106). Lift up the FRONT STABILIZER(7) to move the Stamina® Exercise
Bike.
FUNCTION INSPECTION:
Visually inspect the Stamina® Exercise Bike to verify that assembly is as shown in the above
illustration. Check the function of the Stamina® Exercise Bike by turning the crank slowly through one
complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(30) and
verify that it functions properly and the resistance changes.
CAUTION: Locate and read the CAUTION LABEL(83) on the Stamina® Exercise Bike. Make sure that
all users read the CAUTION LABEL(83) before using the product.
12
Equipment Mat
(not included)