Installation; Removal; Mounting The Microphone - Alpine CDE-126BT Owner's Manual

Installation

CAUTION
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
Less than 35°
1
Remove the mounting sleeve from the main unit (Refer to
"Removal" on page 32). Slide the mounting sleeve into the
dashboard and fix it with the metal shackles.
Bracket
Mounting Sleeve
Dashboard
(Included)
Pressure Plates
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the CDE-126BT/CDE-125BT and
put the Rubber Cap on the hex bolt. If your vehicle does
not have the Mounting Support, reinforce the head unit
with the metal mounting strap (not supplied). Connect all
the leads of the CDE-126BT/CDE-125BT according to
details described in the CONNECTIONS section.
Metal Mounting Strap
Hex Nut (M5)
For the screw , provide a proper screw to the chassis installing
location.
3
Slide the CDE-126BT/CDE-125BT into the dashboard.
When the unit is in place, make sure the locking pins are
fully seated in the down position. This can be done by
pressing firmly in on the unit while pushing the locking
pin down with a small screwdriver. This ensures that the
32
-EN
Rubber Cap (Included)
Hex Bolt
(Included)
*
This unit
Screw
*
Bolt Stud
This unit
unit is properly locked and will not accidentally come out
from the dashboard. Install the detachable front panel.

Removal

1
Remove the detachable front panel.
2
Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3
Pull the unit out, keeping it unlocked as you do so.
JAPANESE CAR
This unit

Mounting the Microphone

Lock Pin
Front Frame
Screw (M5 × 8)
(Included)
Mounting Bracket