Presetting Stations Automatically; Tuning To Preset Stations; Rds; Turning Af (Alternative Frequencies) On/Off - Alpine CDE-126BT Owner's Manual

Presetting Stations Automatically

1
Press BANDTA repeatedly until the desired radio band is
displayed.
2
Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.

Tuning to Preset Stations

Select the band, and then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Note
• If the  indicator is illuminated, turn off the indicator by pressing
FUNC.SETUP, and then you can perform the operation.
10
-EN

RDS

Rotary encoder
BAND/TA FUNC./SETUP
  /ENT 1/AF
/SOUND

Turning AF (Alternative Frequencies) ON/OFF

1
Press FUNC.SETUP so that the  indicator lights up.
2
Press 1AF to select the AF (Alternative Frequency) ON
or OFF mode.
3
Press FUNC.SETUP to activate the preset mode.
The  indicator goes out.
Notes
• When the AF ON mode is selected, the unit automatically tunes to a
strong signal station in the AF list.
• Use the AF OFF mode when automatic re-tuning is not required.
• Operate the unit while the  indicator lights up. If no operation is
performed for 10 seconds, the  indicator goes out.
The RDS digital data includes the following:
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
EON Enhanced Other Networks

Receiving RDS Regional (Local) Stations

1
Press and hold FUNC.SETUP for at least 2 seconds to
activate the SETUP mode.
2
Turn the Rotary encoder to select the REGIONAL mode,
and then press ENT.
3
Turn the Rotary encoder to select ON or OFF.
In the OFF mode, the unit automatically keeps receiving the
related local RDS station.
VIEW