Setting The Aux+ Level (Aux In Gain); Setting The External Digital Input; Setting The Aux Mode (V-Link); Connecting To An External Amplifier - Alpine CDA-117Ri Owner's Manual

 Setting item: AUX+ Setup
Setting contents:
ON / OFF (Initial setting)
ON :
Set to ON when a portable device is connected. If SOURCE is
pressed and AUX+ is selected, the sound of the portable device is
input to the unit.
You can change the AUX+ Name display when AUX+ Setup is
set to ON. Press ENTER when AUX+ Setup is set to ON,
and select AUX+ Name by turning the Rotary encoder, then
press ENTER. After that, turn the Rotary encoder to
select the desired AUX+ Name.
OFF:
When set to OFF, AUX+ source cannot be selected.

Setting the AUX+ Level (AUX IN GAIN)

 Setting item: AUX IN GAIN
Setting contents:
Low (Initial setting) / High
Low:
Decreases the external input audio level.
High:
Increases the external input audio level.

Setting the External Digital Input

ENTER
ENTER
 Setting item: Digital AUX
Setting contents:
ON / OFF (Initial setting)
Notes
• Press SOURCE, and select the D.Aux mode, and adjust the volume,
etc.
• After input selection is completed, turn the ignition off and back on
again. Setting of the optical digital input switch is completed.
• Depending on the connected audio processor, DVD player sound may
continue to be output, even though the source is changed to another
one. If this occurs, set the DVD player's power to OFF.

Setting the AUX Mode (V-Link)

ENTER
Rotary encoder
22
-EN
Rotary encoder
Rotary encoder
ENTER
Rotary encoder
 Setting item: AUX IN
Setting contents:
ON / OFF (Initial setting)
Note
• Via KCA-410C, up to 2 external devices with RCA output can be
connected. In this case, press SOURCE to select AUX mode and
then press BAND/TA to select your desired device.

Connecting to an External Amplifier

 Setting item: Power IC
Setting contents:
ON (Initial setting) / OFF
Power IC ON :
The speakers are driven by the built-in amplifier.
Power IC OFF :
Use this mode when the line output of this unit is used to drive an
external amplifier. In this setting, the head unit's internal amplifier
is turned OFF and can not drive speakers.
POWER IC ON:
SPEAKER
RIGHT FRONT
SPEAKER
RIGHT REAR
SPEAKER
LEFT REAR
SPEAKER
LEFT FRONT
POWER IC OFF:
Note
• No sound is produced by the system when the Power IC is set to OFF.
Speakers
Front
right
Rear
right
Rear
left
Front
left
Front
left
Amplifier
Front
right
Rear
left
Amplifier
Rear
right