Radio
Rotary encoder/ENTER/
BAND/TA
/ESC
SOURCE/
TUNE/A.ME
FUNC.
Listening to Radio
1
Press SOURCE to select TUNER mode.
2
Press BANDTA repeatedly until the desired radio band is
displayed.
FM1 FM2 FM3 MW LW FM1
3
Press TUNEA.ME to select the tuning mode.
DX (Distance mode) LOCAL (Local mode) MANUAL (Manual
mode) DX (Distance mode)
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or will change the frequency
continuously.
Presetting Stations Manually
1
Tune in the station you want to store. Press and hold, for at
least 2 seconds, any one of the preset buttons (1 through
6) into which you wish to store the station.
The display shows the band, preset number and station
frequency memorized.
Notes
• A total of 30 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2, FM3, MW and LW).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
• If the (F) indicator is illuminated, turn off the indicator by pressing
FUNC., then you can perform the operation.
Preset buttons
(1 through 6)
Presetting Stations Automatically
1
Press BANDTA repeatedly until the desired radio band is
displayed.
2
Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
1
Select the desired band, then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Note
• If the (F) indicator is illuminated, turn off the indicator by pressing
FUNC., then you can perform the operation.
Frequency Search Function
1
Press and hold ENTER for at least 2 seconds in Radio
mode to activate Frequency search mode.
2
Turn the Rotary encoder to select the desired frequency.
3
Press ENTER to receive the selected frequency.
Note
• Press ESC in the search mode to cancel. Or, the search mode will
be cancelled if no operation is performed for 10 seconds.
9
-EN