Adjusting Volume; Lowering Volume Quickly; Setting The Time And Calendar; Radio - Alpine CDA-9887 Owner's Manual

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press /RTN to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing /RTN again will bring the audio back to its
previous level.

Setting the Time and Calendar

1
Press and hold FUNC./SETUP for at least 2 seconds
to activate the SETUP selection mode.
2
Turn the Rotary encoder to select the GENERAL
mode, and then press
Bluetooth GENERAL
Bluetooth
3
Turn the Rotary encoder to select Clock Adjust,
and then press / /ENT.
4
Turn the Rotary encoder to set year.
5
Press / /ENT.
6
Repeat steps 4 and 5 above to set month, day, hour
and minute.
7
Press and hold FUNC./SETUP for at least 2 seconds
to return to normal mode.
• Pressing /RTN returns to the previous SETUP mode.
• If no operation is performed for 60 seconds, SETUP is cancelled.
• To synchronise the clock to another clock/watch or radio time
announcement, press and hold
after setting the "hour". Minutes will reset to 00. If the display shows
over "30" minutes when you do this, the time will advance one hour.
/ /ENT.
AUDIO DISPLAY
/ /ENT for at least 2 seconds

Radio

Rotary encoder
/ /ENT
TUNE/A.ME SOURCE/
/ESC

Listening to Radio

1
Press SOURCE/ to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
FM1 FM2 AM FM1
3
Press TUNE/A.ME to select the tuning mode.
DX (Distance mode) LOCAL (Local mode)
MANUAL (Manual mode)
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or
continuously.

Presetting Stations Manually

1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6) into which you wish
to store the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorised.
• A total of 18 stations can be stored in the preset memory (6 stations
for each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
BAND
Preset buttons
(1 through 6)
DX (Distance mode)
will change the frequency
7
-EN