Table of Contents
Advertisement
Operation
Dimmer Curves
Control Panel Lock
Password
Reset
Whites Setting
White Calibration
-10-
This setting determines how fast the output of the COLORado™ Deco Quad 1 Tour
changes when you modify the values of the Red, Green, Blue, White, and Dimmer
faders. This setting provides four different options to simulate the dimming curve of an
incandescent lighting product.
1. Go to the SEt main level.
2. Select diN.
3. Select a dimmer curve (oFF, 1, 2, 3, or 4).
oFF:
The output is proportional (linear) to the Dimmer and RGBW channel
values.
1~4:
The output follows the Dimmer and RGBW channel values based on the
corresponding dimmer curve, being 1 the fastest and 4 the slowest.
This setting enables you to activate or disable the control panel lock.
1. Go to the LoC main level.
2. Select oN or oFF.
When the control panel lock is active, the product will prompt you to enter the
password after 30 seconds of control panel inactivity.
After being prompted to enter the password:
Press <UP>, <DOWN>, <UP>, <DOWN>, <MENU>.
This setting allows you to reset the COLORado™ Deco Quad 1 Tour to the default
values, including the custom programs.
1. Go to the SEt main level.
2. Select rSt.
3. Enter the master access password as described in Password.
4. Wait for the reset process to finish.
This setting allows you to select and edit the temperature of the white colors used in
channel 6 (Macros) when in the tor mode.
1. Go to the CAL main level.
2. Enter the master access password as described in
3. Go to ytE.
4. Select a white color (y.01~11).
5. Select a color (rEd, grN, bLU, or yte).
6. Select a color value (000~255).
7. Repeat for the other colors.
This setting allows you to select the white color shown by the COLORado™ Deco Quad
1 Tour when the color setting is rgb and the DMX controller's Red, Green, and Blue
faders are set to "255."
1. Go to the CAL main level.
2. Enter the master access password as described in
3. Go to rgb.
4. Select a color (rEd, grN, or bLU).
5. Select a color value (000~255).
6. Repeat for the other colors.
When selecting CAL > rgb, you will only be able to define the values of RED,
GREEN, and BLUE.
The values of RED, GREEN, and BLUE configured from CAL > rgb will define the
color temperature shown when the RGB faders are set to "255" if SEt > CoL > rgb
is active.
Password.
Password.
COLORado™ Deco Quad 1 Tour User Manual Rev. 1
Advertisement
Table of Contents
