Advertisement
3. Type change feature-access-codes and press Enter
4. In the Auto Route Selection (ARS) - Access Code 1 field specify the correct access
code for outside dialing. For example, type 9 if users must dial 9 to get an outside line.
5. Type change ars analysis n and press Enter to configure the route selection based
on the number dialed following the access code.
For example, type 720 if users must dial the area code 720 after dialing 9 for outbound
local calls.
6. Type change route-pattern n and press Enter to define the SIP trunk groups to be
selected for the corresponding route pattern.
7. Set Secure SIP field to N.
8. Type change locations and press Enter.
9. In the Proxy Sel. Rte. Pat. field, designate the SIP trunk routing patterns from step 6. This
provides support for features such as call transfer.
Refer to the Call Routing Guide available on the Avaya Support Web site
support.avaya.com) for more information
Verifying network connectivity
1. To verify network connectivity on the Avaya G860 Media Gateway:
a. In the right pane under the MGs List, select the entry corresponding to the Avaya
G860 Media Gateway that you configured.
b. Select the MG Status tab to display a replica of the front panel.
c. Double-click on the active TP6310 card shown in black and select
d. Verify that the icons for the DS3 entries are green.
e. Double-click on the DS3 entry for the DS1 channel interface parameters that you
configured.
f. Verify that the icons for the DS1 entries are green.
2. To verify network connectivity on the TN799DP C-LAN circuit packs:
a. Log into Communication Manager on the S8720 Media Server and start a SAT
session.
b. Type ping IPAddress board location, where IPAddress is the Ethernet
interface on the G860 Media Gateway and location is the board location of the
C-LAN circuit pack within the G650 Media Gateway.
c. Type status signaling-group and press Enter.
Avaya G860 Media Gateway Setup
Verifying network connectivity
03-601863, Issue 1, November 2007
(http://
27
Advertisement
