Advertisement
10. In the Direct IP-IP Audio Connections?: field, type y.
11. Accept the default values on the remaining fields.
12. Press Enter to save your changes.
If using more than one C-LAN for load balancing, repeat these steps for the each C-LAN.
Adding a trunk group
You must add the active TPM to a signaling group before starting this procedure. See
signaling group
!
Important:
The number of trunk members must be distributed across all the trunk groups
Important:
used for the G860 Media Gateway.
1. Type add trunk-group next and press Enter.
The system automatically assigns the next available trunk group number, which shows in
the Group Number field.
2. In the Group Type field, type or select sip.
3. In the Group Name field, type a name for this trunk group as it relates to the active TPM.
4. In the COR: field, type 1.
5. In the TAC field, type a valid number that fits your dial plan.
For more information about dial plans in Communication Manager, see the Administrator
Guide for Avaya Communication Manager, 03-300509, at
6. In the Direction field set the value to two-way.
7. In the Service Type field, type or select tie.
8. In the Signaling Group field, type the number of the signaling group to which the active
TPM is assigned.
9. In the Number of Members field, type the number of members that you wish to use for
this trunk group.
Note:
The maximum number of trunk group members in any one signaling group is 255.
Note:
The maximum number of total members is based upon your license agreement. If
you have more than 255 trunk group members in a signaling group, you must
create additional signaling groups.
10. In the Trunk Features section, set the Numbering Format field to public.
Avaya G860 Media Gateway Setup
on page 24.
Avaya Communication Manager configuration
http://
www.avaya.com/support.
03-601863, Issue 1, November 2007
Adding a
25
Advertisement
