Advertisement
Avaya G860 Media Gateway Setup
For more information about determining the best routing and alternate routing configurations,
contact an Avaya software specialist.
Configuring inbound call routing on the TPM
The Trunk Processing Module (TPM) must be locked before starting these steps.
on page 9
the TPM
Note:
The two rules set up in these steps implement a form of load sharing that is based
Note:
on the calling numbers of the inbound traffic.
1. Double-click the locked TPM shown in black.
2. Select the SIP tab.
3. Select the Routing tab to display the SIP Tel to IP Routing List.
4. Click the + icon to add a routing rule.
Routing rules are applied to inbound calls (DS3 > SIP).
5. In the Name field, type an appropriate name.
6. In the Source Phone Prefix field, type a match specification, where x matches any digit
in the calling number and [x-y] specifies that the digit in hat position should match any
digit in the range x to y.
7. In the Dest Address field, type the IP address of the TN799DP C-LAN circuit pack to
which the incoming PSTN call is sent.
For example, if the last digit of the calling number ends in 0, 1, 2, 3, or 4, then a SIP
INVITE is sent to C-LAN1. See the table in Call Routing Configuration.
8. Click Apply and then Close.
18
Avaya G860 Media Gateway Setup
.
See
03-601863, Issue 1, November 2007
Locking
Advertisement
