Operation; Starting Up The Projector; Switching Input Signal - BenQ GP10 User Manual

Operation

Starting up the projector

1. Connect the power using the power cord. The Power indicator turns into orange.
2. Press
control to start the projector. The Power
indicator lights green when the projector is
on.
The start up procedure takes several seconds.
In the later stage of start up, a startup logo is
projected.
(If necessary) Rotate the focus ring to adjust
the image clearness.
3. If the projector is activated for the first time, select your OSD language following the
onscreen instructions.
4. If you are prompted for a password, press the
arrow keys to enter a six digit password. See
"Utilizing the password function" on page 29
for details.
5. Switch all of the connected equipment on.
6. The projector will display the home screen.
If the frequency/resolution of the input signal exceeds
the projector's operating range, you will see the
message 'Out of Range' displayed on a blank screen.
Please change to an input signal which is compatible with the projector's resolution or set the
input signal to a lower setting. See

Switching input signal

The projector can be connected to multiple devices
at the same time. However, it can only display one
full screen at a time. Press
or remote control to select your desired input
signal.
• The input signal type effects the options available
for the Picture Mode. See
mode" on page 32
• The native display resolution of this projector is in a
16:10 aspect ratio. For best display picture results, you should select and use an input signal
which outputs at this resolution. Any other resolutions will be scaled by the projector
depending upon the 'aspect ratio' setting, which may cause some image distortion or loss of
picture clarity. See
Operation
26
Power on the projector or remote
I
I
/
"Selecting a picture
for details.
"Selecting the aspect ratio" on page 31
"Timing chart" on page 71
on the projector
for details.
for details.