Fingerprint Reader Board - HP EliteBook 1040 G1 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes cable)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the keyboard (see
7. Remove the heat sink/fan assembly (see
8. Remove the system board (see
Remove the fingerprint reader board:
1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the board to the computer.
2. Remove the bracket from atop the fingerprint reader board (2).
3. Remove the fingerprint reader board and cable from the computer (3).
Reverse this procedure to install the fingerprint reader board.
Bottom cover on page
Battery on page 41).
Keyboard on page 50)
Heat sink/fan assembly on page
System board on page
35)
59)
61)
Component replacement procedures
Spare part number
739567-001
65