Display Assembly Components (Panel, Bezel, Webcam, Microphone) - HP EliteBook 1040 G1 Maintenance And Service Manual

Display assembly components (panel, bezel, webcam, microphone)

All display assemblies include WLAN antenna transceivers and cables. WWAN models also include 2 WWAN
antenna transceivers and cables.
Full hinge-up displays are not spared.
This section describes removing components that do not require that you entirely remove the display
assembly from the computer. You can remove the display bezel, webcam/microphone module, and display
panel with the display assembly still attached to the computer.
To remove the remaining display components, including the display brackets, antennas, and enclosure, you
must remove the entire display assembly from the computer. See
information about removing the remaining components.
Description
Display panels (35.6-cm [14.0-in], anti-glare, LED)
SVA HD+
UVWA
Display bezels
For use with models with a webcam
For use with models without a webcam
Webcam module with microphone
Microphone module
Before removing the display panel, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Remove the display assembly components:
1. Position the computer upright, with the front toward you.
2. Open the computer as far as possible.
3. If it is necessary to replace the display bezel:
a. Close the computer, position it so you can access the bottom of the display, and then open the
computer slightly.
Battery on page 41).
Display assembly on page 37
Spare part number
739581-001
739582-001
739568-001
748015-001
739570-001
739571-001
Component replacement procedures
for more
31