Expansion Board Options - HP ProLiant DL G6 User Manual

Power up the server (on page 22,
17.

Expansion board options

The server supports up to ten PCIe expansion boards. For more information, see "System board components
(on page 13)."
IMPORTANT:
expansion slot 1.
To install the component:
Power down the server (on page 22).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 25).
3.
Remove fan 5 (on page 26).
4.
If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27).
5.
Remove the air baffle (on page 28).
6.
Open the expansion board retainer.
7.
"Powering up and configuring the
The HP SAS Expander Card and the HP NC524SFP Adapter are not supported in
server" on page 40).
("Open or remove the tower
Hardware options installation 78
bezel" on page 22).