Table of Contents
Advertisement
Example 4 – Set Up the Ethernet Router to Activate on Matching Caller IDs Only:
On the
1.
PPP > PPP Configuration
PPP General
●
Make sure that PPP is Enabled.
●
Make sure Dial-on-Demand is Enabled.
●
Set the Idle Time Out to the number of seconds you desire.
Authentication
●
Your wireless service provider may require you to have a separate PPP username and password. If
so, enter them here.
Note:
when you activated your account.
Modem Configuration
●
Make sure your Dial Number is entered correctly: The Dial Number is *99***1#
Submit
●
Click the Submit button to save the changes made on this screen.
On the
2.
PPP > Wakeup-on-Call
Wakeup-on-Call Configuration
●
Select Enable for Wakeup-on-Call.
●
Set the Time Delay. Use can use the 10 second default.
●
Enter the Init Strings:
●
Submit Button
Click the Submit button to save these settings.
Caller ID Configuration
●
Enter a caller's ID that you want added to the Caller ID list.
●
Add Button
Click the Add button to save each Caller ID as it is entered to the Caller ID list.
3.
Save and Restart
Click Save and Restart once you have completed and submitted all the screens on which you have made
changes. The device will save all the settings and reboot the PC.
Multi-Tech Systems, Inc. MultiModem rCell User Guide
screen, set up the following parameters:
If a username and password are required, your wireless provider would have given them to you
screen, set up the following parameters:
Set Wakeup Init String 1 by entering AT+CLIP=1
Chapter 3 – Using the Web Management Software
33
Advertisement
Table of Contents
