Table of Contents
Advertisement
General Configuration
The system date and time display in these formats: MM/DD/YYYY / HH:MM:SS. A real time clock is part of
Date and Time:
SNTP to display proper time.
IP Configuration
Enter the following addresses for the Ethernet interface.
IP Address (Default = 192.168.2.1), Mask (Default 255.255.255.0), Default Gateway (Default 0.0.0.0),
Primary DNS (Default 0.0.0.0), Secondary DNS (Default 0.0.0.0).
See Appendix A – Table of Commonly Supported Subnets.
Note:
Auto Dialout Configuration
Check the box to enable/disable Auto Dialout. Default = Enable. The Auto Dialout settings allow you to use the
Auto Dialout:
integraded cellular modem directly with no router functionality. This is accomplished using redirector software on your pc. This
software creates a virtual serial port allowing your pc to communicate with the integrated cellular modem over IP using telnet.
Check the box to enable/disable raw mode for an Auto Dialout session. Default = Disable.
Raw Dialout:
Check the box to enable or disable Auto Dialout Login feature. Default = Enable. The auto Dialout ort is
Auto Dialout Login:
the telnet port used by the redirector software on yout pc to communicate to the integrated cellular modem.
Enter the serial Auto Dialout Port number. Default = 5000.
Auto Dialout Port:
Check the box to enable/disable the EIA standard signal characteristics (time and duration) used
Handle EIA Signal:
between different electronic devices.
Enter the time in seconds that the auto dialout session will stay active before going inactive.
Inactivity:
Syslog Configuration
Check the box to enable or disable Syslog. Default = Disable.
Syslog:
Syslog Server IP Address:
Auto Discovery
Check the box to enable or disable Auto Discovery to broadcast (MAC level), the MAC Address, IP Address,
Auto Discovery:
and DHCP information to the configured server port. Default = Enable. The router will send a broadcast packet on the
specified server port every 10 seconds or whatever interval the broadcast timer is set to.
Enter the Server Port Number. Default port is 1020.
Server Port:
Enter the amount of time in seconds for the auto-discovery packet granularity of periodic broadcasting.
Broadcast Timer:
Default is 10 seconds.
Auto Reboot Timer Configuration
Enter the number of hours to lapse between each automatic reboot. The default of zero deactivates the
Auto Reboot Timer:
timer. Range is 0 to 999.
Telnet Configuration
Enables/Disables the Telnet port. The default is Enable. This is specifically for telnet port 23 for technical support debug. You
can still access the integrated cellular modem using port 5000 when this is disabled.
Submit Button
Click the Submit button to save these settings.
You must click Save and Restart once you have completed and submitted all the screens on which you have made
Note:
changes.
Multi-Tech Systems, Inc. MultiModem rCell User Guide
If a Remote Syslog Server IP Address is specified, the syslog feature acts as a remote Syslog.
Chapter 3 – Using the Web Management Software
23
Advertisement
Table of Contents
