Multitech MultiModem rCell MTCBA-H-EN2 User Manual page 29

PPP General
PPP
Dial-on-Demand:
Idle Time Out:
Connect Time Out:
Dialing Max Retries:
Authentication
Authentication Type:
User Name:
Password:
ICMP Keep Alive Check
Keep Alive Check:
Keep Alive Type:
Host Name:
TCP Port:
Interval:
ICMP Count:
Modem Configuration
Dial Number:
Dial Prefix:
Connect String:
APN:
Init String 1-4:
Submit Button
Click the Submit button to save these settings.
You must click Save and Restart once you have completed and submitted all the screens on which you have made
Note:
changes.
The MTCBA-H-EN2 is shipped with command AT^SLED=1 entered at Init String 2. If the MTCBA-H-EN2 is set back to
Note:
factory default using the pushbutton on the back of the chassis, this command will need to be reentered and saved as Init
String 2 for the LS LED to display properly.
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Enable/disable PPP. The default is Disable. When enabled, the unit functions as a router.
PPP must be disabled to access the integrated cellular modem directly using telnet port
5000. If PPP is enabled, you cannot access the integrated cellular modem.
Enable/disable Dial-on-Demand. The default is Disable. If you disable it, the router will
always stay connected unless the Idle Time Out expires. When Dial-on-Demand is enabled,
use the 'Wakeup on Call' settings under the PPP menu to configure the settings for re-
establishment of the connection.
Set the amount of idle time that will pass before the router will timeout. The default is 180
seconds. If the time expires, the PPP connection to the internet will disconnect. Any IP
packets from the LAN side or IP traffic from the wireless side will reset this timer and prevent
the connection from dropping.
Set the number of seconds to wait for a connection while in receive mode before timing out.
Enter the number of dialing retries allowed. The default is zero, which means an infinite
number is allowed. Range 0 to 100.
Set the authentication protocol type that will negotiate with the remote peer: pap/chap/pap-
chap. Default is pap-chap.
Enter the User Name with which the remote peer will authenticate. Default is ipmodule. You
can leave this field blank, if desired. User Name is limited to 60 characters.
Enter the Password with which the remote peer will authenticate. Default is ipmodule. You
can leave this field blank, if desired. Password is limited to 60 characters.
Enable/disable Keep Alive Check. The default is Disable. This is used to periodically check
that the internet connection is up. If it is not, the router will try to reconnect.
Select ICMP or TCP (the protocol type for Keep Alive).
Enter the Host Name or IP Address for Keep Alive Check. No default.
Enter the TCP Port number to connect with the TCP server.
Set the number of seconds for Keep Alive Check. Default is 30 seconds.
Set the number of ICMP Keep Alive Checks to be sent to the specified host. Default is 10.
(Refer to the Customer Activation Notices included with the product for proper information to
enter).
Set the dial number to be dialed. Default is NULL. The dial number is *99***1#.
Set the modem dial prefix. The default is ATDT.
Set the modem Connect String. The default is CONNECT.
Enter the APN (Access Point Name). The APN is assigned by your wireless service
provider.
Configure the modem init strings. You can set up to 4 modem initialization strings.
Chapter 3 – Using the Web Management Software
29