Table of Contents
Advertisement
Chapter 3 – Using the Web Management Software
Example 3 – Set Up the Ethernet Router to Activate on ALL Incoming Calls
On the
1.
PPP >PPP Configuration
PPP General
●
Make sure that PPP is Enabled.
●
Make sure Dial-on-Demand is Enabled.
●
Set the Idle Time Out to the number of seconds you desire.
Authentication
●
Your wireless service provider may require you to have a separate PPP User name and Password. If
so, enter them here.
If a user name and password are required, your wireless provider would have given them to you when
Note:
you activated your account.
Modem Configuration
●
Make sure your Dial Number is entered correctly: The Dial Number is *99***1#
Submit
●
Click the Submit button to save the changes made on this screen.
On the
2.
PPP > Wakeup-on-Call
Wakeup-on-Call Configuration
●
Select Enable for Wakeup-on-Call.
●
Set the Time Delay to 3 seconds. You can use the 10 second default.
●
All Init Strings should be empty.
●
Submit Button
Click the Submit button to save these settings.
Caller ID Configuration
●
Enter the string RING to the Caller ID list.
●
Click the Add Button to save the string to the Caller ID list.
3.
Save and Restart
Click Save and Restart once you have completed and submitted all the screens on which you have made
changes. The device will save all the settings and reboot the PC.
32
screen, set up the following parameters:
screen, set up the following parameters:
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Advertisement
Table of Contents
