Table of Contents
Advertisement
Chapter 3 – Using the Web Management Software
IP Setup > SNTP Configuration
General Configuration
Enable or disable the SNTP Client to contact the configured server on the UDP port 123 and set the local
SNTP Client:
time. The default is Disable.
Enter the SNTP server name or IP address to which the SNTP Client must contact in order to update the
Server:
time. No default.
Enter the polling time at which the SNTP client requests the server to update the time. Default is 300
Polling Time:
minutes. Time must be entered in minutes.
Time Zone Configuration
Enter your time zone. Default = UTC (Universal Coordination).
Time Zone:
See the following Web site for Time Zone
information:
Enter +/- hh:mm. Default = +00:00. Offset is the amount of time varying from the standard time of a
Time Zone Offset:
Time Zone.
Daylight Configuration
Enables/disables Daylight Saving mode. The default is Enable.
Daylight Saving:
Set the offset to use during Daylight Saving mode. Default is +60 minutes. Enter the time in + / -
Daylight Saving Offset:
minutes.
Daylight Saving Start Time
Set the start ordinal to use during Daylight Saving mode. Options are first/second/third/fourth/last. Default
Start Ordinal:
is first. Daylight Saving time usually starts at the same time on the same day of the week in the same
month every year. Each day of the week occurs four or five times a month. Therefore, you will be selecting
the week in which daylight saving time starts: the first, second, third, fourth or the last of the month.
26
http://wwp.greenwichmeantime.com/info/timezone.htm
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Advertisement
Table of Contents
