Procedure 4: Modifying The Default Ip Service Settings; Fast Configuration Wizard - Polycom RealPresence Getting Started Manual

Procedure 4: Modifying the Default IP Service Settings

The Fast Configuration Wizard is automatically started when no Default IP Network Service is
defined and it assists you in configuring the Default IP Network Service. This happens during
First Time Power-up, before the service has been defined or if the Signaling Service has been
deleted, followed by an Collaboration Server restart.
The IP Management Service tab in the Fast Configuration Wizard is enabled only if the factory
default Management IP addresses were not modified.

Fast Configuration Wizard

1
Polycom, Inc.
Enter the required IP information in the dialog box.
Table 2-2 Fast Configuration Wizard – IP Signaling
Field
Network Service
Name
Signaling Host
IP Address
Media Card 1
IP Addresses
Subnet Mask
Description
The name Default IP Service is assigned to the IP Network Service by
the Fast Configuration Wizard. This name can be changed.
Note: This field is displayed in all IP Signaling dialog boxes and can
contain character sets that use Unicode encoding.
In the RealPresence Collaboration Server 800s, this field is disabled
as only one IP address is used for the Signaling Host and the Media
Card and it is defined by the Media Card IP address.
In the RealPresence Collaboration Server 800s, one IP address is
used for the signaling and media.
Enter the address to be used by IP endpoints when dialing into the
MCU.
Dial out calls from the Collaboration Server are initiated from this
address.
This address is used to register the Collaboration Server with a
Gatekeeper or a SIP Proxy server.
Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
Chapter 2-First Time Installation and Configuration
2-11