Table of Contents
Advertisement
User's Manual PNVR200 series
4.9.14.
System
BOOTING EVENT: This event occurs when the NVR is
booting.
LOGIN FAIL EVENT: This event occurs when the NVR
fails to log in. You can specify the times of clicking <
> to trigger the event.
FAN FAIL EVENT : This event occurs if the CPU
cooling fan or unit's cooling fan does not work at all.
! If the fan fails, no recording will proceed by the
NVR. If you encounter a fan failure, contact the
retailer or the service center for technical
assistance.
TEMPERATURE FAIL EVENT : This event occurs if the internal temperature of the NVR exceeds the effective
range. Then, the NVR will not operate normally. If this is the case, check the followings and take a necessary
measure.
- Check if the ventilation of the NVR is clogged with foreign substances. If so, remove them.
- Keep the NVR away from a heat source such as heater. Install it in a flat, lower area with good ventilation.
- If the problem persists, contact the retailer or service center.
POE FAIL EVENT : This event occurs if power consumption reaches specified level of power supply capacity of
NVR and external PoE Hub.
! To monitor the normal operation of the NVR, it is recommended not to change the buzzer output settings of the fan
failure event and the temperature fail event.
4.9.15.
Network
TROUBLE IN INTERNET CONNECTION : Occurs if the
Internet connection to the NVR fails. If you do not
want to connect the NVR to the network, leave the
<ACTION> item blank.
FAIL IN REMOTE LOGIN : This event occurs if a
remote client fails to log in due to an invalid ID or
password. You can specify the times of clicking < >
to trigger the event.
FAIL IN DDNS UPDATE : This event occurs if the NVR
tried to update the DDNS address but failed.
! If the DDNS address fails to be updated, the NVR
may not connect to a remote client. If this is the
case, enter the IP address from the client side to
allow access from the NVR. This is just a temporary
measure. For the IP address, move to and check
<EXTERNAL IP ADDRESS> from the <NETWORK>
window. Note that the <EXTERNAL IP ADDRESS> is
subject to change if the NVR does not use the static
IP.
! Note that the <EXTERNAL IP ADDRESS> can
change at any time in a dynamic IP environment.
57
Advertisement
Table of Contents
