Table of Contents
Advertisement
User's Manual PNVR200 series
4.9.8.
Alarm Sensor
You can configure the settings of the alarm sensor and specify the operation of the sensor if an event occurs.
1. From <SYSTEM SETUP> - <EVENT>, select <ALARM
SENSOR>.
2. Use the [▲▼◀▶] buttons on the remote
control or use the mouse to specify the sensor
input method and operation.
NAME : You can specify the name of the
alarm sensor.
OPERATION : You can specify the type of the
alarm sensor.
- N/O (Normal Open) : Normally the sensor is
left Open. If the sensor switches to Close, an
event will be triggered.
- N/C (Normal Close) : Normally the sensor is
left Close. If the sensor switches to Open, an
event will be triggered.
LINKED CAMERA : Set the camera to sync with the alarm sensor if it is triggered. If you have set the alarm
recording and the sensor detects the recording, all synchronized cameras will start alarm recording
ALARM OUTPUT : Specify the alarm output channel if it is detected by the alarm sensor. The alarm will be
output to the specified channel.
PRESET : On alarm sensor's detections, the camera moves as defined by the selected preset.
BUZZER : Specify the output of the buzzer if an alarm is detected by the alarm sensor.
VIDEO POPUP : Select to display the video popup if an alarm is detected by the alarm sensor. If there exist
multiple <LINKED CAMERA>, the video popup will be displayed in the maximum split mode.
OSD POPUP : Select to display the OSD popup message if it is detected by the alarm sensor.
EMAIL : Select to send an email if detected by the alarm sensor.
FTP : Select whether to upload event notification onto the FTP upon detected alarm event.
3. To apply the change, click <APPLY> in the bottom of the screen.
4.
When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen to return to the
previous menu.
54
Advertisement
Table of Contents
