Ddns; Email - Orion PNVR204 4CH User Manual

User's Manual PNVR200 series
4.6.2.

DDNS

You can configure the DDNS settings so that remote users who are connected to the network can access remotely.
DDNS is an IP redirection service in a dynamic IP environment that redirects (maps) the new IP address to a registered
domain name each time the IP address is changed.
1. From <SYSTEM SETUP> - <NETWORK>, select
<DDNS>.
2. Use the [▲▼◀▶/ENTER] buttons on the remote
control or use the mouse to specify the use of DDNS
and select a server.
> DDNS : Specify the use of DDNS connection.
> DDNS SERVER : Select a server to connect to.
> NVR NAME : Enter the name of the NVR that you
want to use as DDNS.
> DDNS REGISTRATION TEST : Check if the <NVR
NAME> can be set as DDNS. If there is a duplicate
name in the server, the registration will fail. If this is
the case, rename the < NVR NAME > and press Test
to check if it works properly.
> USER NAME : Use this field only if you set DDNS
server to dyndns.org.
> PASSWORD : Use this field only if you set DDNS
server to dyndns.org.
> NVR ADDRESS : Provide the <NVR NAME> and
press the <DDNS REGISTRATION TEST> button. The
name will be added automatically.
> DDNS CONNECTION TEST : Perform the connection
test to check if DDNS is normally registered.
3. To apply the change, click <APPLY> in the bottom of
the screen.
4. When done, press the [exit] button on the remote
control or click <CLOSE> in the lower screen to return
to the previous menu.
4.6.3.

Email

You can register and test an email address so that an email notification is delivered at a specific interval or if an event
occurs.
1. From <SYSTEM SETUP> - <NETWORK>, select
<EMAIL>.
2. Use the [▲▼◀▶/ENTER] buttons on the remote
control or use the mouse to specify the use of email
and select a server.
> SERVER : Set up the mail server. Set the mail server
that will be used for notification to the NVR. Use the
virtual keyboard to enter your mail server.
> PORT : Enter the mail server port.
> SECURITY : If it is set to <ON>, the email will be
transferred in secure mode. If it is set to <OFF>, the
email will be transferred to a server that does not
support SSL.
> USER : Provide the email account (ID) of the
sender.
> PASSWORD : Provide the password of the sender.
42