Detail Status; Security; Encryption; Ip Filter - Orion PNVR204 4CH User Manual

User's Manual PNVR200 series
4.6.6.

Detail Status

You can check the details of the cameras that are
connected to each channel.
Click < > in the right area of the list to show the
details.
Click <RESET> in the "IP CAMERA CONFIGURATION"
window to reset the IP camera.
When the IP camera settings are complete, click <OK>.
4.6.7.

Security

For security purpose, you can set whether to use encryption and its method, and configure IP filtering.
1. From <SYSTEM SETUP> - <NETWORK>, select <SECURITY>.
2. Use the [▲▼◀▶/ENTER] buttons on the remote control or use the mouse to select one between
<ENCRYPTION> and <iP FilteR>.
3. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen to return to the
previous menu.
4.6.8.

ENCRYPTION


RTSP ENCRYPTION ENABLE : Set whether to
apply RTSP encryption or not.

RTSP ENCRYPTION METHOD : Select the
encryption method.

HTTPS ENABLE : Set whether to use HTTPS
encryption or not.

HTTP AUTHENTICATION METHOD : Select the
authentication method for encrypted
communication.
4.6.9.

IP FILTER


IP FILTER ENABLE : Set whether to apply IP filter or
not.

IP FILTER RULE : You can set to allow or deny IP
addresses listed in the IP filter.

ADD : Click the button to add an IP address to be
filtered, if IP filtering is enabled.
44