Table of Contents
Advertisement
User's Manual PNVR200 series
> TEST EMAIL ADDRESS : Enter an email address for
the test purpose.
> TEST : Send a test email and check if the test email
is delivered normally.
3. To apply the change, click <APPLY> in the bottom of
the screen.
4.
When done, press the [EXIT] button on the remote
control or click <CLOSE> in the lower screen to return
to the previous menu.
4.6.4.
Network Status
From the network map screen, you can check the internet connection status and IP camera connection status, and
check also the details of the connection status for each camera.
1. From <SYSTEM SETUP> - <NETWORK>, select <NETWORK STATUS>.
2. Use the [▲▼◀▶/ENTER] buttons on the remote control or use the mouse to select one between <NETWORK
MAP> and <DETAIL STATUS>.
3. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen to return to the
previous menu.
4.6.5.
Network Map
IP ADDRESS : Indicates the internal IP address of the
NVR.
MAC ADDRESS : Indicates the internal MACaddress of
the NVR.
DDNS ADDRESS : Indicates the internal DDNS address
of the NVR.
RTSP SERVICE PORT : Indicates the network port of
the video service. For remote service, the router
must have set up the port forwarding.
WEB SERVICE PORT : Indicates the webservice
network port. For the remote service to be enabled,
the corresponding port of the router should have set
up the port forwarding.
DDNS UPDATE STATUS : Shows if the DDNS address was registered to the DDNS server normally. Press <
try to register the DDNS address forcibly
EXTERNAL IP ADDRESS : Indicate the IP address for the Internet, accessible from the NVR. The NVR can be granted
access with the web browser at "http://<external iP address>:<web Service Port>". The IP address can vary in a
dynamic IP environment.
CONNECTED CLIENTS : Shows the list of clients that are currently connected. Press < > to terminate the
connection of an unwanted client forcibly.
Termination is limited to only users in a lower group than the current user.
! The current PoE power consumption is updated sequentially in the order of channel.
! Alarm is generated if power consumption reaches 90% of rated supply capacity, for both NVR main unit and external
PoE Hub. This alarm threshold setting can be edited in "EVENT > SYSTEM EVENT > POE FAIL EVENT".
43
> to
Advertisement
Table of Contents
