User's Manual PNVR200 series
2.2. Basic Layout
2.3. Precautions
To secure recording stability from an overloaded network traffic, hacking attempt or DoS (Denial of Service) attack,
only the direct cable connection between camera and NVR is allowed.
! Using a hub is allowed only for extending single channel for extended transfer range to 100m each.
Any access from an outside PC to the IP camera will be strictly prohibited for the purpose of secure operation.
! Signal connection for POS and ATM is scheduled to be upgraded later.
2.4.
Connecting to an external device
2.4.1.
Connecting to the monitor
The product supports 1080p 60Hz monitors with HDMI connection and 1920x1080 resolutions DVI monitors only.
Connect the HDMI cable between HDMI output port in the bottom rear panel and HDMI port of the monitor, or use
the HDMI to DVI cable to connect to the DVI port of the monitor.
2.4.2.
Power connection
Two adaptors are provided: one for NVR operation (DC 12V), and the other for PoE (Power Over Ethernet, 48V).
2.4.3.
NVR power connection
Plug the provided DC 12V adaptor in the rear power port of the NVR.
2.4.4.
Poe Switching hub power connection
Plug the provided DC 48V adaptor in the rear power port of the NVR.
When done, attach the adaptor cable clip to the rear panel and insert the cable in.
14