2.9
General Ethernet Setup
This section describes the Ethernet Setup Menu that you will configure depending on the
particular protocol TCP/IP, IPX, or Bridge you are using on your LAN. From the Main Menu,
enter 3, then the Menu 3- Ethernet Setup displays as shown in Figure 2-11.
This menu determines the type of the filter sets you wish to implement to monitor your Ethernet
traffic. From Menu 3 - Ethernet Setup, enter 1 to go to Menu 3.1 -General Ethernet Setup.
1. General Setup
2. TCP/IP and DHCP Setup
3. Novell IPX Setup
4. Bridge Setup
Enter Menu Selection Number:
Figure 2-11.
Menu 3.1 - General Ethernet Setup
Input Filter Sets=
Output Filter Sets=
Press ENTER to Confirm or ESC to Cancel:
Figure 2-12.
Menu 3.1 - General Ethernet Setup
Chapter 2 Hardware Installation & Initial Setup
Menu 3 - Ethernet Setup
Menu 3 - Ethernet Setup
Prestige 128MH PSTN Router/Hub
2-21