ZyXEL Communications Prestige 128MH User Manual page 104

Prestige 128MH PSTN Router/Hub
Table 6-1. Remote Node Network Layer Options for a TCP/IP Configuration
Field
Route
IP Address
Edit IP/IPX/Bridge
Rem IP Address
Rem IP Subnet
Mask
My WAN Addr
Single User
Account
Server IP address
Chapter 6 TCP/IP Configuration for LAN-to-LAN
6-4
Description
Make sure [IP] is among the protocols in the Route field.
Enter the IP address of the gateway at the remote site (in this
case, headquarters). If the remote router is using a different IP
address than the one entered here, your Prestige will drop the
call.
Press the space bar to change it to [Yes] and press [Enter] to
go to Menu 11.3 - Remote Node Network Layer Options Menu.
This will show the IP address you entered for this Remote Node
in the previous menu.
Enter the subnet mask for the remote network.
Some implementations, especially the UNIX derivatives,
require hosts on both ends of the PSTN/ISDN link to have
separate addresses from the LAN, and that the addresses must
have the same network number. If this is the case, enter the IP
address assigned to the WAN port of your Prestige.
Note that this is the address assigned to your local Prestige,
not the remote router.
(See Figure 6-3 for an explanation of My WAN Addr. With
Sample IP Addresses)
This field should be set to [Yes] to enable the Single User
Account (Network Address Translation) feature for this site.
Use the space bar to toggle between [Yes] and [No]. See
Chapter 3 - Internet Access Application for more information on
the Single User Account feature.
If you are using the Single User Account feature and you want
to make a server on your LAN (for example, a Web server)
accessible to outside users, enter that servers IP address here.
Option
[IP]
([IP/IPX/IP+IPX])
[Yes]
([Yes/No])
[Yes/No]