Table of Contents
Advertisement
Figure A-1
3. Upgrading with a USB Stick
1.
Connect the USB stick with the upgrade file saved on it to the USB port on the front
panel (see
Figure
2.
Select USB Upgrade and press SEL. The UPGRADE starts automatically.
3.
After the process is complete, press SEL to return to the DVR Diagnostics screen.
4.
Repeat steps 2 and 3 again, then move on to step 5.
5.
After the upgrade is complete, select Boot Application and press SEL to reboot the
DVR with the updated firmware.
4. Verifying Software Installation
1.
Press SETUP and log on.
2.
Select SYSTEM and press SEL.
3.
Select DESCRIPTION and press SEL.
4.
Check the version displayed. This should match to the new software version you have
installed.
Rev 3.01
Engineering Mode
3-1).
56
Document 900.0399
08/08
Advertisement
Table of Contents
