Pc And Compatibles Installation; Installing The Interface Card - Ricoh ImageReader FB User Manual

2400 dpi flatbed scanner with 30-bit super color

Table of Contents

Scanner Installation

PC and compatibles installation

Installation of

following instructions walk you through installing the interface card into your PC, and connecting the

scanner and cable. It is important to note that both the scanning hardware and its supporting software

(e.g. Info Technician and the included applications) must be installed in order for the scanner to

operate.

The installation of the scanner's interface card is a simple process. Because your PC is designed with

room for additional peripherals, the manual that was provided with your computer contains complete

guidelines for case removal and expansion card installation. The graphic and instructions provided

here are intended to supplement that information.

Caution! As a safety precaution, the power to the computer and all peripheral equipment should be off

Caution!

and disconnected from the power source. Touch a grounded object before making contact with any

components. Electrostatic discharge can damage the interface card and computer components.

To install the interface card:

I .

Remove the computer's housing.

2 .

On the computer's mother board, select an available 16-bit ISA expansion slot, and remove its rear

access cover. The slot must be free of dust and dirt to ensure a good connection.

3 .

align the gold-striped connector

slot as displayed in the diagram

Chapter 2

the scanner is comprised of few steps and designed to be as easy as possible. The

Hold the scanner interface card by the upper edge, and

with the expansion slot. Press the card firmly into the

the next page.

Table of Contents