Others Menu (Submenu) - Roland EGX-350 User Manual

5-5 Description of Menu Items

Others Menu (Submenu)

P. 85, "Submenus"
90 Chapter 5 Feature reference
This determines whether the spindle is rotated during cutting. When this is set
to "OFF," scribing (cutting without rotation of the spindle) is performed.
➢ Default setting: ON
Set this to "ON" in cases such as when you're using the nose unit. Setting this to
"ON" enables automatic detection of the Z origin point as the position where
the tip of the nose unit or cutter touches the surface of the workpiece.
When the lock lever is positioned at
"ON" may cause an error and make operation impossible to continue.
➢ Default setting: OFF
This is displayed when [AUTO Z CONTROL] is set to "ON." This sets the cut-
out amount when [AUTO Z CONTROL] is set to "ON."
➢ Default setting: 500 (5 mm)
This selects a resolution that matches the program used to create the engraving
data. When you're performing output from the included Windows-based driver,
set this to "0.1mm."
➢ Default setting: 0.01 mm
The cutter stops moving when a command is received that specifies movement
outside the range of operation for the X and Y axes. Movement starts again
when a command to return from that location to the range of operation is re-
ceived. You can select either of the following as the response taken when this
occurs.
➢ [CONTINUE]:
When a command for return to the range of operation is received, operation
resumes immediately.
➢ [PAUSE]:
When a command for return to the range of operation is received, operation
is paused and the Pause menu appears on the display screen. Use the opera-
tion panel to select the operation to perform thereafter.
P. 49, "Pausing and Resuming Cutting"
➢Default setting:
CONTINUE
, set this to "OFF." Leaving this set at