Roland EGX-350 User Manual page 83

Move the spindle head to the front left of the workpiece table, then attach the vacuum adapter for chip cleaning as
shown in the figure. Using the vacuum adapter for chip cleaning enables the vacuum cleaner to take up cutting waste
during cutting, which can help keep scattering of cutting waste to a minimum.
P. 44, "Manual Movement"
Front
Nose unit
Vacuum adapter
clamp
Retaining
screw
Tab
Tab
Position so that the retaining screw
for the nose unit is between the tabs
of the clamp.
Top
Hose
Provide a gap large enough
to ensure no striking.
Note: Wind the clip around the hose to hold the hose securely so that it won't easily come loose.
5-1 Attaching the Vacuum Adapter for Chip Cleaning
Hose
Clip
Secure using the clip. *
Rear
Hose
32mm
Pass through above the bar.
(1.3 in.)
Hose
Clip
Secure using the clip. *
Chapter 5 Feature reference
Bar
81