Roland EGX-350 User Manual page 65

—
➀
Wrench
Spindle unit
➁
Wrench
2.
Set the lock lever.
4-5 Cutter Installation Method 2 (No Nose Unit)
Install the solid collet.
➀
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit
from below, then, while holding the
spindle unit immobile with a wrench,
tighten loosely.
Use an appropriate solid collet for the
cutter's diameter.
Solid collet
➁
Fully tighten the solid collet.
Using two wrenches, tighten the solid
collet fully. The appropriate tightening
torque is 3.2 N-m (32kgf-cm) .
Wrench
Set the lock lever at the
The spindle head is secured in place.
P. 82, "The Position of the Lock Lever"
Lock lever
Lift up.
position.
Chapter 4 Engraving 63