Roland EGX-350 User Manual page 70

4-6 Cutter Installation Method 3 (Diamond Scraper)
—
Wrench
Spindle unit
Wrench
2.
Set the lock lever.
68 Chapter 4 Engraving
➀
➁
Install the solid collet.
➀
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit
from below, then, while holding the
spindle unit immobile with a wrench,
tighten loosely.
Diameter-4.36 millimeter diamond scrap-
ers cannot be used with the included solid
collet. Provide a dedicated diamond-
scraper collet separately.
Solid collet
➁
Fully tighten the solid collet.
Using two wrenches, tighten the solid
collet fully. The appropriate tightening
torque is 3.2 N-m (32kgf-cm) .
Wrench
Set the lock lever at the
tion.
For detailed information about the setting
position for the lock lever, refer to the page
Lock lever
indicated below.
Press down to lower
slightly.
P. 82, "The Position of the Lock Lever"
or posi-